Floor-Standing Air Conditioner with Humidity Control — Constant Temperature and Humidity Units for Precision Environments

It is an air conditioner that holds both temperature and humidity to a setpoint at the same time — a constant temperature and humidity unit. Unlike a comfort AC, which only removes moisture incidentally while cooling, it actively dehumidifies when the room is too humid and humidifies when it is too dry, while also cooling or heating to hold the temperature. The result is a stable, controlled climate held to a tight tolerance, typically ±1°C and ±5% RH.

A normal split or central AC controls temperature only and cannot raise humidity or hold RH to a setpoint. A portable air conditioner is a mobile spot cooler — it cools a local area and has no precision humidity control. A floor-standing air conditioner with humidity control integrates dehumidification, humidification, cooling, and heating in one fixed cabinet and holds both temperature and humidity to spec. They solve different problems: spot cooling vs precision climate control.

Yes — that is the defining feature. The unit dehumidifies when humidity is above the setpoint and humidifies when it is below, so it holds the target RH in both directions, across seasons. A standard AC and a standalone dehumidifier can only remove moisture; this unit also adds it, under unified control with the temperature.

Standard configurations hold approximately ±1°C on temperature and ±5% RH on humidity, across a controllable range of roughly 18–30°C and 40–70% RH. Tighter tolerances are available on specification — tell us the required band and stability at the inquiry stage and we configure the control system and component staging to match.

Floor-standing (floor-mounted) is the industry standard form factor for precision temperature-and-humidity units because the cabinet houses the larger compressor, dehumidification coil, humidifier, and heater needed for full four-function control. Wall-split and portable units lack the capacity and integrated components to hold both setpoints. Where the condenser must sit outside the room, the unit splits into a floor-standing indoor unit and an outdoor unit.

Any environment where both temperature and humidity must stay within a tight band: electronics and semiconductor production (ESD and corrosion control), laboratories and metrology/calibration rooms, pharmaceutical and chemical process and storage areas, cleanrooms, tobacco/cigar and specialty food aging, and archive/museum/precision storage. These need coordinated control that a comfort AC plus a separate dehumidifier cannot provide.

Yes. SHISHUO is a manufacturer and configures each unit to the project — capacity staging, integrated or split configuration, control and logging, and tolerance band. We support OEM (your branding on our hardware) and ODM (modified hardware) for cleanroom and lab contractors, facility builders, and distributors. Process follows our catalog 6-step flow from requirement analysis through testing and shipping.

Standard units run on 220V/50Hz and 380V three-phase; 110V/60Hz and 240V/50Hz are available on ODM specification. We are an export manufacturer and ship internationally — contact us with your room conditions, target temperature and humidity band, and destination market for a configured recommendation, certificates where applicable, and a quotation.